Version 6.6 149 October 2014
Installation & Operation Manual 21. Software Installation and Basic Configuration
9. At the Enable Security prompt, type 1 to enable the Mediant 8000 software
operate in Secure Mode or 0 to leave Mediant 8000 software in its default mode.
For more information, see Section 'Secure Operation Mode' on page 306.
Enable Security (0-no, 1-yes) [0]:0
Note: If your system uses SC- Rev.2 boards (with the Linux OS), the “Enable
Security” prompt does not appear as the software always operates in a Secure
Mode. See 'Secure Operation Mode' on page 306 for details.
10. At the SC Root Password prompt, enter the new password for user root or
press Enter to leave it unchanged. Re-enter the new password when prompted.
Use the following rules when specifying a new root password:
• Password must have at least 8 characters.
• Password must contain at least two alphabetic characters and at least one
numeric or special character. In this case, "alphabetic" refers to all upper or
lower case letters.
• Password must differ from the user's login name (root) and any reverse or
circular shift of that login name.
SC Root Password [leave unchanged]: ******
Note: For security reasons, it is strongly recommended to change root password
from it’s default value. Make a note of the new password you enter and keep it in a
secure location for future reference.
11. After all basic configuration parameters are prompted, a summary of the settings
is displayed.
Configuration Summary:
Global SC IP Address : 10.7.13.90
1
st
SC IP Address : 10.7.13.91
2
nd
SC IP Address : 10.7.13.92
Enable Security : 0 (no)
SC Root Password : ******
12. You are prompted to start configuring. To commence the configuration, type y
and press Enter.
To Next Page
Loading...
