Installation & Operation Manual 234 Document # LTRT-92224
Mediant 8000
4. When prompted to proceed with the Linux OS re-installation, type y and press
Enter.
Do you wish to proceed with Linux OS re-installation? (y/n) : y
5. The current IP network configuration is displayed. This configuration is preserved
after the Linux OS re-installation. Verify that the configuration is correct and type
y and press Enter to proceed with the re-installation.
This SC board has the following IP configuration:
Hostname : sc2-linux
IP Address : 10.7.21.4
Network Mask : 255.255.0.0
Default Gateway : 10.7.0.1
This configuration will be preserved after the Linux OS re-installation
and you will be able to re-connect to the SC board's IP address
(10.7.21.4) via the SSH.
Is the above IP configuration correct? (y/n) : y
6. After the Linux OS re-installation, only acladmin and root users will remain on
the SC board. You will be prompted to enter the default password for each user.
Enter the passwords as prompted and use them to re-connect to the SC board
when the Linux OS re-installation has completed.
After Linux OS re-installation only the following 2 users will remain on
the SC board:
1) acladmin
2) root
When Linux OS re-installation completes, you should re-establish SSH
connection with the SC board, login as user "acladmin" and then, if
required, type "su -" command to switch to the "root" user.
You will now be prompted for the default passwords that will be used
after Linux OS re-installation.
Enter default password for "acladmin" user : pass_1234
Enter default password for "root" user : root
7. When prompted to start the Linux OS re-installation, type y and press Enter.
Ready to perform Linux OS re-installation.
SC board will now be rebooted and Linux OS will be re-installed on it.
Re-installation will take approximately 15 minutes and will be performed
in a fully automatic mode. During the re-installation SC board will be
inaccessible via the network (i.e. all SSH connections will be dropped).
You may optionally use RS-232 serial console to monitor re-installation
progress.
When re-installation completes, SC board will be rebooted and you will be
able to connect to it via the SSH.
Start Linux OS re-installation? (y/n) : y
To Next Page
Loading...
