Version 6.6 237 October 2014
Installation & Operation Manual 27. Working with the SC Boards
8. When the re-installation has completed, the SC board will be rebooted.
After the Linux OS re-installation via the RS-232 console, the SC board will be
inaccessible from the IP network (it will be assigned a non-routable local link IP
address) and only the following default users with default passwords will be
defined on it:
Default Username Default Password
root root
acladmin pass_1234
Therefore you must use the following procedure to change the default user
passwords and make the SC board accessible via the IP network by configuring
the basic SC board’s network parameters.
To configure the basic SC board’s network parameters after the Linux OS re-
installation:
1. Use the RS-232 serial console to connect to the SC board’s CLI interface. For
more information,see 'Command Line Interface' on page 107.
2. Login as the root user. For more information, see Section 'Logging in as a Root
User' on page 115.
3. To change the default password for acladmin user, type passwd acladmin and
enter the new password. To change the default password for root user, type
passwd root and enter the new password.
4. To configure the SC board’s IP network parameter, at the prompt type network-
config and press Enter.
[root@sc-board ~]# network-config
5. The current SC board’s network configuration is displayed and you will be
prompted to change it. Type y and press Enter.
Current network configuration:
Hostname : sc-board
IP Address : 169.254.100.1
Subnet Mask : 255.255.0.0
Default Gateway : 169.254.0.1
Do you wish to change it? (y/[n]) : y
6. When prompted, enter the Hostname, IP Address, Subnet Mask and Default
Gateway for the SC board. It is strongly recommended to provide the same
values as were defined prior to the Linux OS re-installation.
Hostname : sc2-linux
IP Address : 10.7.21.4
Subnet Mask : 255.255.0.0
Default Gateway : 10.7.0.1
To Next Page
Loading...
