Installation & Operation Manual 284 Document # LTRT-92224
Mediant 8000
Parameter Name Type
Provisioning
Type
Description
Network Subnet Integer
0 – 10
Online Defines index of the Network Subnet to be
used for communication with the specific
Virtual Gateway. Default value 0 means that
the first Control Subnet will be used.
Local Port Integer
0 – 65535
Online Defines the port to be used by the Media
Gateway Controller to communicate with this
Virtual GW.
Default value (0) means that the port is
selected according to encoding method
(2944, 2945).
Message
Identifier
String
Up to 200
chars
Online Defines Message Identifier (MID). If set to not
empty value, overrides the MG/Board FQDN.
By default, "[IP address]:Port" MID is used.
Load Weight Integer
1 – 5
Online Defines the weight of the VGW out of the
total load. VGW with higher values process
more messages. The priority is applicable
between VGW with different network
configuration (port, transport type, realm).
Media Realm Integer
0 – 16
Online Defines the default Media Realm.
MEGACO
Version
Integer
1 – 3
Online Defines the version of the MEGACO protocol.
Service Change
Profile
String
Up to 64 chars
Online Defines the service change profile.
Associated
Trunks List
String
Up to 64 chars
Online Defines the list of the E1/T1 trunks that
belong to specific Virtual Gateway.
Trunks are specified by their number (index).
Multiple trunks may be specified using
comma delimiter (for enumeration) or dash
delimiter (for range definitions). E.g.
"1,2,4,10-13".
A special line can be used as the default
group. This line MUST contain the string
DEFAULT LINE. Every trunk which is not
defined in one of the other groups will belong
to this line. Note that if two default lines are
entered, the first one only will be used.
Each E1/T1 trunk may belong to one VGW
only.
To Next Page
Loading...
