Version 6.6 291 October 2014
Installation & Operation Manual 31. Configuring the MGCP/MEGACO Protocols
Parameter Name Type
Provisioning
Type
Description
MGCP Timeout -
1st ReTx
Integer
50 – 1000
Instant Defines the MGCP timeout for the first
retransmission (in msec). The retransmission
intervals thereafter increase exponentially.
MGCP Comm
T/out Layer
Integer
1 – 3600
Instant Defines the maximum time to wait for an
MGCP response before declaring a
disconnection (in sec). Used for
retransmission.
Use Wildcard
With RSIP
Enum
Trunk, Board
Or TPM
Online This parameter applies to MGCP only.
Defines the RSIP Restart messages
generation level. When set to Trunk, RSIP
Restart messages are generated on a per-
trunk basis. When set to Board Or TPM,
RSIP Restart messages are generated on a
per-board basis.
DLCX by GW Enum
Enable,
Disable
Instant This parameter applies to MGCP only.
Enables a Delete connection (DLCX)
message from the media gateway side.
Disconnect On
Broken
Connection
Enum
NotConfigured,
Disable,
Enable
Instant Defines whether the device releases the call
if RTP packets are not received within a user-
defined timeout. The timeout is set by the
parameter Broken Connection Timeout.
Broken
Connection
Timeout (100
msec)
Integer
3 – 21474836
Instant Defines the amount of time (in 100 msec
units) an RTP packet isn’t received, after
which a call is disconnected. Applicable only
if Disconnect On Broken Connection
parameter is set to Enabled. Currently this
feature works only if Silence Suppression is
disabled.
Digit Map Name String
Up to 10 chars
Online Defines the name of the provisioned digit
map.
Digit Mapping String
Up to 151
chars
Online Defines the digit map patterns separated by a
vertical bar (|), as defined in the MEGACO
RFC.
To Next Page
Loading...
