Installation & Operation Manual 314 Document # LTRT-92224
Mediant 8000
tg_6.6.32.install with the name of the latest Mediant 8000 installation package.
Don’t forget to specify os_patch as the last command argument.
client241::~# install ~acladmin/tg_6.6.32.install os_patch
Core Network Media Gateway
Version : 6.6.15
OS patches installation
WARNING: installation of OS patches may take up to 1 hour
and may require reboot of the SC board.
To minimize the effect on Media Gateway service, install OS patches on
the Standby SC board first (typically in Slot 2), then perform SC
switchover and install OS patches on the remaining SC board.
Note: On SC boards with v5.6 or earlier software version installed, the install
command may produce no output. In that case, use the following commands to start
the Mediant 8000 software installation:
rm -f os_patch
chmod u+x ~acladmin/tg_6.6.32.install
~acladmin/tg_6.6.32.install os_patch
7. When you are prompted if you wish to start installation, type y and press Enter.
The OS patches installation begins.
Start installation? (y/n) : y
Extracting /tmp/sc_software.tar installation archive... done
Extracting OS patches... done
Applying 118558-39 (1 of 2)… done
Applying 140426-01 (2 of 2)… done (reboot required)
The following OS patches were successfully installed: 118558-39; 140426-
01.
8. Wait patiently till the OS patches installation completes. For SC Rev.1 boards
(using the Solaris OS) it may take up to 1 hour to install the latest OS patches.
For SC Rev.2 boards (using the Linux OS), the OS patches installation typically
takes less than 5 minutes.
9. After the OS patches installation successfully completes, you are prompted to
reboot the SC board. At the prompt, type y and press Enter.
To Next Page
Loading...
