Installation & Operation Manual 374 Document # LTRT-92224
Mediant 8000
4. At the Choose submenu prompt, type pwd and press Enter. The CHANGE
USER PASSWORD menu appears.
Choose submenu : pwd
CHANGE USER PASSWORD
5. At the User Name prompt, type the desired username and press Enter.
6. At the When password should expire prompt, type the password expiration
date (number of days). To configure a password without an expiration date, type
0.
When password should expire? ([0-never]/number of days) : 100
Note: For improved security, it is strongly recommended to use an expiration date
for all passwords.
7. At the Prevent too often password changes prompt, type the minimum interval
between password changes (number of days). For not limiting the password
change time interval, type 0.
Prevent too often password changes? ([0-no]/number of days) : 1
Note: For improved security, it is strongly recommended to limit password changes
to not more than 1 change per day. This limitation affects only password change
operations performed by users. The administrative super-user (root) may alter the
password of any user regardless of any time limitations.
8. At the New Password prompt, type the new password.
New Password:*******
9. At the Re-enter new Password prompt, type the new password again.
Re-enter new Password:*******
The new password is configured on the Active SC board and immediately
replicated to the Standby SC board. Therefore, there is no need to repeat steps
1-9 on the Standby SC.
To Next Page
Loading...
