Installation & Operation Manual 488 Document # LTRT-92224
Mediant 8000
10. Determine all possible routing paths to the destination SS7 signaling node and
configure SS7 Routes for each alternative adjacent SS7 signaling node that
may be used for reaching the destination.
Note: Each SS7 Linkset can be attached to more than one SS7 Routeset.
a. In the Navigation pane, select the SS7 Routeset configured in step 9.
b. In the Navigation pane, select SS7 Routes; the SS7 Routes list is displayed.
c. Select a specific row and then in the configuration pane, click SS7 Route
Settings; the SS7 Route Settings screen is displayed.
d. Configure the SS7 Route properties according to the table 'MTP3/M3UA -
SS7 Route Properties'. Make sure to attach it to the SS7 Linkset configured
in step 7.
11. Create and configure an M3UA Routing Group and Context that defines routing
rules for M3UA messages based on their source point codes and service
indicators.
a. Click
to access the Media Gateway Status screen.
b. Select the desired Media Gateway board.
c. In the Navigation pane, select PSTN
SS7 M3UA Routing Groups; the
M3UA Routing Group list is displayed.
d. Use the
or buttons to add or remove entries.
e. Select a specific row and in the Navigation pane select M3UA Routing
Contexts; the M3UA Routing Contexts list is displayed.
f. Use the
or buttons to add or remove entries.
g. Select a specific row and then in the configuration pane, click M3UA
Routing Context Settings; the M3UA Routing Context Settings screen is
displayed.
h. Configure the M3UA Routing Context properties according to the table
'M3UA Routing Context Properties'.
12. Create and configure the UAL Group for each SCTP association that is
established with the SoftSwitch.
a. Click
to access the Media Gateway Status screen.
b. Select the desired Media Gateway board.
c. In the Navigation pane, select PSTN
Sigtran UAL Groups; the UAL
Group list is displayed.
d. Use the
or buttons to add or remove entries.
e. Select a specific row and then in the configuration pane, click UAL Group
Settings; the UAL Group Settings screen is displayed.
To Next Page
Loading...
