AudioCodes Mediant 8000 - Page 496

Installation & Operation Manual 496 Document # LTRT-92224
Mediant 8000
Parameter Name Type Provisioning Type Description
OPC 1 String
Up to 20
chars.
Online Defines the 1
st
filter Originating Point
Code. MTP3 messages that originate at
a specific point code will be associated
with this M3UA Routing Context. An
empty value means that the filter is
deactivated.
Can be specified in numeric (e.g. 15) or
X-Y-Z (e.g. 0-1-1) formats.
ANSI point code uses 24-bits. It consists
of three octets - network, cluster and
member octet. An octet is a 8-bit byte
which can contain any value between 0
and 255.
ITU point code uses 14 bits. It is a pure
binary number that can be stated in
terms of zone (3 bits), area/network (8
bits) and signaling point identification (3
bits) numbers.
China point code uses 24-bits and is
incompatible with both ANSI and ITU
networks.
OPC 2 String
Up to 20
chars.
Online Defines 2
nd
filter Originating Point Code.
MTP3 messages that originate at
specific point code will be associated
with this M3UA Routing Context. An
empty value means that the filter is
deactivated.
OPC 3 String
Up to 20
chars.
Online Defines 3
rd
filter Originating Point Code.
MTP3 messages that originate at a
specific point code will be associated
with this M3UA Routing Context. An
empty value means that the filter is
deactivated.
OPC 4 String
Up to 20
chars.
Online Defines 4
th
filter Originating Point Code.
MTP3 messages that originate at a
specific point code will be associated
with this M3UA Routing Context. An
empty value means that the filter is
deactivated.
Service Indicator 1 Enum
none,0-15
Online Defines the 1
st
filter Service Indicator.
MTP3 messages that match a specific
SI will be associated with this M3UA
Routing Context. The value 'none'
means that the filter is deactivated.