Installation & Operation Manual 580 Document # LTRT-92224
Mediant 8000
Parameter Name Type
Provisioning
Type
Description
SourceIP Address
Input
Enum
Auto
Decision,
SIP Contact
Header,
Layer 3
Source IP
Instant Defines the IP address that the gateway
uses to determine the source of incoming
INVITE messages for IP-to-Tel routing.
Auto Decision – if the IP-to-IP feature is
enabled, this parameter is automatically
set to Layer 3 Source IP. If the IPto-IP
feature is disabled, this parameter is
automatically set to SIP Contact Header.
SIP Contact Header – use the IP
address in the Contact header of the
incoming INVITE message.
Layer 3 Source IP – Use the actual IP
address (Layer 3) from which the SIP
packet was received.
Tel to IP NO answer
Timeout (Sec)
Integer
0 – 3600
Instant Defines the time (in seconds) that the
gateway waits for a 200 OK response from
the called party (IP side) after sending an
INVITE message. If the timer expires, the
call is released.
Replace Calling With
Redirect Number
Enum
Disable,
Enable
Instant Enables replacing the calling number with
the redirect number in ISDN-to-IP calls.
When such a replacement occurs, the
calling name is deleted and left blank. The
outgoing INVITE message does not include
the redirect number that was used to
replace the calling number. The
replacement is performed only if a redirect
number is present in the incoming call.
Tel2IP Call Forking
Mode
Enum
Disable,
Enable
Instant Enables the Tel-to-IP Call Forking feature;
the device can send a Tel call to multiple IP
destinations.
An incoming Tel call with multiple matched
routing rules (e.g., all with the same source
prefix numbers) can be sent (forked) to
multiple IP destinations if the rules are
defined with a Forking Group in the SIP
Routing Tel to IP table .
Enable Alternative
Manipulation Tel2IP
Enum
Disable,
Enable
Instant Enables different number manipulation rules
for redundant calls.
Enable Alternative
Routing
Enum
No, Yes
Instant Enables or disables the Alternative Routing
feature for Tel-to-IP calls.