AudioCodes Mediant 8000 - Page 588

Installation & Operation Manual 588 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type
Provisioning
Type
Description
 Trunk Cyclic Ascending – Select the
media server port from the first channel
of the next trunk (next to the trunk from
which the previous channel was
allocated.
 ISDN SuppServ Table - The BRI
port/module is selected according to the
settings in the ISDN Supplementary
Services table , allowing the routing of IP-
to-Tel calls to specific BRI endpoints
 Dest Number Ascending -The device
allocates a channels to incoming IP-to-
Tel calls as follows:
 The device attempts to route the
call to the channel that is
associated with the destination
(called) number. If located, the
call is sent to that channel.
 If the number is not located or
the channel is unavailable (e.g.,
busy), the device searches in
ascending order for the next
available channel in the Trunk
Group. If located, the call is sent
to that channel.
 If all the channels are
unavailable, the call is released.
 Note: If this parameter is not
configured for the Trunk Group,
then its channel select method is
according to the global
parameter, ChannelSelectMode.
Use EndPoint
Number As
Calling Number
Tel2IP
Enum
Enable,Disable
Instant Enables the use of the B-channel number as
the calling number (sent in the From header
of the INVITE) instead of the number
received in the Q.931 Setup message, for
Tel-to-IP calls.
For example, if the incoming calling party
number in the Q.931 Setup message is
"12345" and the B-channel number is 17,
then the outgoing INVITE From header is set
to "17" instead of "12345".
Note: When enabled, this feature is applied
before routing and manipulation on the
source number.