Installation & Operation Manual 598 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type
Provisioning
Type
Description
Out-of-Service
Behavior
Enum
Default, ISDN
Service Msg,
ISDN D-Channel,
Alarm, CAS Block
Instant Defines the method for setting digital trunks
to Out-Of-Service state per device.
Default – The default behavior is as
follows:
For ISDN: Use Service messages on
supporting variants and Alarm on non-
supporting variants.
For CAS: Use Alarm.
ISDN Service Msg – Sends ISDN In or
Out of Service (only for ISDN protocols
that support Service message).
ISDN D-Channel – Takes D-Channel
down or up (ISDN only).
Alarm – Sends or clears PSTN AIS Alarm
(ISDN and CAS).
CAS Block – Blocks trunk (CAS only).
Notes:
To determine the method for setting Out-Of-
Service state per trunk, use the Trunk Out-
Of-Service Behavior parameter (see ''Trunk/
SIP Parameters Settings'').
Enable CIC Enum
No, Yes
Instant Defines whether Carrier Identification Code
(CIC) is relayed to ISDN. If enabled, the CIC
code (received in an INVITE Request-URI)
is included in a TNS IE in the ISDN SETUP
message.
ISub Number
Of Digits
Integer
0 – 36
Instant Defines number of digits that are taken from
the end of the phone number for the Sub
Address.
B-Channel
Negotiation
Enum
Preferred,
Exclusive, Any
Instant Defines the ISDN B-channel negotiation
mode. Applicable to ISDN protocols. The
option ‘Any’ is only applicable to the User
side.
Enable ISDN
UUI to SIP
Enum
Disable, Enable
Instant Enables transfer of User-to-User Information
Element (UUIE) from PRI Setup message to
SIP INVITE message. The IE is transferred
using a proprietary 'X-UserToUser' SIP
header.
Enable SIP UUI
to ISDN
Enum
Disable, Enable
Instant Enables transfer of (UUIE) from SIP INVITE
message to PRI Setup message. The IE is
received using a proprietary 'X-UserToUser'
SIP header.
To Next Page
Loading...
