EasyManua.ls Logo

AudioCodes Mediant 8000 - Page 624

AudioCodes Mediant 8000
924 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation & Operation Manual 624 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type
Provisioning
Type
Description
Host Name String
Up to 49
chars
Instant Defines the Address of Record (AOR) host name. It
appears in REGISTER From/To headers as
ContactUser@HostName. For successful
registrations, this HostName is also included in the
INVITE requests' From header URI. If not configured
or if registration fails, the 'SIP Group Name' parameter
from the 'IP Group' table is used instead.
Register Enum
No, Yes
Instant Enables registration.
When enabled, the device sends REGISTER requests
to the Serving IP Group. In addition, to activate
registration, you also need to set the parameter
'Registration Mode' to 'Per Account' in the 'Trunk
Group Settings' table for the specific Trunk Group.
The Host Name (i.e., host name in SIP From/To
headers) and Contact User (user in From/To and
Contact headers) are taken from this table upon a
successful registration.
Notes:
The Trunk Group account registration is not
effected by the parameter Is Register Needed.
You can configure this table so that a specific IP
Group can register to multiple ITSP's.This is
performed by defining several rows in this table
containing the same Served IP Group, but with
different Serving IP Groups, user/password, Host
Name and Contact User parameters.
If registration to an IP Group(s) fails for all the
accounts defined in this table for a specific Trunk
Group, and if this Trunk Group includes all the
channels in the Trunk, the Trunk Group is set to
Out-Of-Service if the parameter Set Out-Of-Service
On Registration Failure is enabled.
Contact User String
Up to 50
chars
Instant Defines the AOR user name that appears in
REGISTER From/To headers as
ContactUser@HostName, and in INVITE/200 OK
Contact headers as ContactUser@<device's IP
address>. If not configured, the 'Contact User'
parameter from the 'IP Group Table' page is used
instead.
Note: If registration fails, then the userpart in the
INVITE Contact header contains the source party
number.

Table of Contents

Related product manuals