Installation & Operation Manual 648 Document # LTRT-92224
Mediant 8000
Rule 6: Sends query for original destination number of received call to the LDAP
server.
Rule 7: Alternative routing rule that sends the call of original dialed number to IP
destination 10.33.45.72. This rule is applied in any of the following cases:
• LDAP functionality is disabled.
• LDAP query is successful but call fails (due to, for example to a busy line) to
all the relevant attribute destinations (private, Lync, PBX, and mobile), and a
relevant Tel-to-IP Release Reason (see Alternative Routing for Tel-to-IP
Calls) or SBC Alternative Routing Reason (see Configuring Alternative
Routing Reasons ) has been configured.
Once the device receives the original incoming call, the first rule that it uses is Rule 6,
which queries the AD server. When the AD replies, the device searches the table,
from the first rule down, for the matching destination phone prefix (i.e., "PRIVATE:,
"PBX:", "OCS:", "MOBILE:", and "LDAP_ERR:"), and then sends the call to the
appropriate destination.
To Next Page
Loading...
