AudioCodes Mediant 8000 - Page 654

Installation & Operation Manual 654 Document # LTRT-92224
Mediant 8000
Parameter Name Type
Provisioning
Type
Description
reaches the highest channel number in
the Trunk Group, it selects the lowest
channel number in the Trunk Group
and then starts ascending again.
 Ascending – Select the lowest
available channel. Always start at the
lowest channel number in the Trunk
Group and if that channel is not
available, select the next higher
channel.
 Cyclic Descending – Select the next
available channel in descending cycle
order. Always select the next lower
channel number in the Trunk Group.
When the media server reaches the
lowest channel number in the Trunk
Group, it selects the highest channel
number in the Trunk Group and then
start descending again.
 Descending – Select the highest
available channel. Always start at the
highest channel number in the Trunk
Group and if that channel is not
available, select the next lower
channel.
 Number + Cyclic Ascending – First
select the media server port according
to the called number (see the note
below). If the called number isnt found,
then select the next available channel
in ascending cyclic order. Note that if
the called number is found, but the port
associated with this number is busy,
the call is released.
 By Source Phone Number – Select the
media server port according to the
calling number (see the note below).
 Trunk Cyclic Ascending – Select the
media server port from the first channel
of the next trunk (next to the trunk from
which the previous channel was
allocated.
 ISDN SuppServ Table - The BRI
port/module is selected according to
the settings in the ISDN
Supplementary Services table ,
allowing the routing of IP-to-Tel calls to