Installation & Operation Manual 656 Document # LTRT-92224
Mediant 8000
Parameter Name Type
Provisioning
Type
Description
global parameter Authentication
Mode), you can exclude some
endpoints from being registered by
assigning them to a Trunk Group and
configuring the Trunk Group
registration mode to 'Don't Register'.
Per Account – Registrations are sent
(or not) to an IP Group, according to
the settings in the Account table
Notes:
To enable Trunk Group registrations,
configure the global Enable
Registration parameter to Yes. This is
unnecessary for 'Per Account'
registration mode.
If no mode is selected, the registration
is performed according to the global
parameter Authentication Mode.
If the Media Gateway is configured
globally (via the Authentication Mode
parameter) to register Per Endpoint,
and a Trunk Group comprised of four
channels is configured to register Per
Gateway, the media gateway registers
all channels except the first four
channels. The Trunk Group of these
four channels sends a single
registration request.
Serving IP
Group
Integer
-1 (Not Defined)
or 1-32
Instant The Serving IP Group ID to where
INVITE messages initiated by this Trunk
Group's endpoints are sent. The actual
destination to where these INVITE
messages are sent is to the Proxy Set ID
(see 'Proxy Sets Table') associated with
this Serving IP Group. The Request URI
hostname in the INVITE and REGISTER
messages (except for 'Per Account'
registration modes) is set to the value of
the field 'SIP Group Name' defined in the
'IP Group'.
If no Serving IP Group ID is selected, the
INVITE messages are sent to the default
Proxy or according to the 'Tel to IP
Routing Table' or 'Tel to IP/Outbound IP
Routing Table'.
Note: If the parameter PreferRouteTable
To Next Page
Loading...
