Installation & Operation Manual 688 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type Provisioning
Type
Description
Dial Plan
Index
Enum
None, Plan1,
Plan2, Plan3,
Plan4, Plan5,
Plan6, Plan7,
Plan8
Instant Defines which dial plan index to use in the
external Dial Plan file. The Dial Plan file is
loaded to the Board as a *.dat file - converted
using AudioCodes DConvert utility. The dial
plan index can be assigned per Tel Profile.
Notes:
If this parameter is used to select a dial
plan index (from the Dial Plan file), the
settings of the parameter Digit Mapping are
ignored.
This parameter is applicable to ISDN E1/T1
with overlap dialing (Receive Overlap
Dialing is set to Enabled).
For E1 CAS MFC-R2 variants (which don't
support terminating digit for the called party
number, usually I-15), this parameter and
the Digit Mapping parameter are ignored.
Instead, you can define a Dial Plan
template per trunk in the 'Trunk Settings'
page.
To Next Page
Loading...
