Installation & Operation Manual 780 Document # LTRT-92224
Mediant 8000
3. At the prompt, type tools bk and press Enter.
client238 -- ~ -- /moGW
• tools bk
The backup sequence is activated. You are prompted to confirm the action. Type
y and press Enter.
BACKUP
This tool will create a complete backup of Media Gateway software
IMPORTANT: you must run this tool only on ACTIVE SC board!!!
Make a backup? ([y]/n) : y
4. You are prompted to enter a name of the backup file or press ENTER to accept
the default file name – backup.bk.
In the example below, the chosen backup file name is backup_12jan2009.bk.
The backup file is created in the home directory of the logged in user (e.g.,
/data/acladmin directory for acladmin user) unless you specify a complete file
name starting with the "/" symbol (e.g., /data/shared/12_jan2009.bk).
It is recommended to end the backup file name with the extension ".bk".
Backup file name [backup.bk] : backup_12jan2009.bk
5. You are prompted to choose whether you wish to include binary files in the
backup or not. Backup without software binary files included is most commonly
used due to much smaller size and faster creation time. However it can be
restored only on the SC board that has a proper SC software version pre-
installed.
Do you wish to include binary files in the backup?
Backup without binary files has significantly smaller size, but
it may be restored only on the SC board with correct SC software
version pre-installed on it.
Include binary files? ([y]/n) : y
To Next Page
Loading...
