Maintenance Object Repair Procedures
555-233-123
10-280 Issue 4 May 2002
Table 10-111. TEST #619 BRI Port Local TDM Loop Around
Error
Code
Te s t
Result Description/Recommendation
1000 ABORT The system resources required to run this test are not
available. The port may be busy with a valid call. Use the
display port PCSSpp command to determine the station
extension or trunk group/member number of the port. Use the
status bri-port PCSSpp command to determine the service
state of the port. If the service state indicates that the port is in
use, then the port is unavailable for certain tests. Wait until
the port is idle before retesting.
1. If the port is idle, then retry the command at 1-minute
intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
TDM-BUS (TDM Bus) Maintenance documentation to
diagnose any active TDM Bus errors.
1. If the system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to TTR-LEV (TTR Level) Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to TONE-PT (Tone Generator) Maintenance
documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call. Use the
status station command for the station associated with this
port and determine when the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
1005 ABORT This test is not valid for this type of translation. Ports
administered as “ASAI” or “ADJK” can not run this test,
because the B channels associated with the port are not used
by ASAI or Avaya Adjunct Links. This is a normal condition.
Continued on next page
To Next Page
Loading...
