BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI
ISDN-BRI Port)
Issue 4 May 2002
10-281 555-233-123
2000 ABORT Response to the test was not received from the BRI-LINE
circuit pack within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit
pack if the other ports are not in use. Reset the circuit
pack by issuing the busyout board PCSS and the reset
board PCSS commands.
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal System Error.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2103 ABORT The system could not make the conference connection for the
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1, 2 FAIL As stated previously, this test runs a TDM Loop Around Test
on each B-channel. This indicates that the loop around failed
on one of the channels. Error Code 1 indicates that the TDM
Loop Around Test failed on B1. Error Code 2 indicates that
the TDM Loop Around Test failed on B2.
7, 8 FAIL As stated previously, this test runs a Conference Circuit Test
on each B-channel. A failure here indicates that one of these
conference tests failed; Error Code 7 means that the test
failed on B1; Error Code 8 means that the test failed on B2.
1. If the test fails repeatedly, attempt to reset the circuit pack
if the other ports on the circuit pack are not in use. Reset
the circuit pack by issuing the busyout board PCSS and
the reset board PCSS commands.
2. If the test fails again, replace the circuit pack.
PASS The BRI Port Local TDM Loop Around Test has passed.
Table 10-111. TEST #619 BRI Port Local TDM Loop Around — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
