CARD-MEM (Memory Card)
Issue 4 May 2002
10-345 555-233-123
Error Log Entries and Test to Clear Values
a. Error Type 1: System detects no memory card in the slot of the
TN2401/TN794 NetPkt or TN777B Netcon circuit pack. If memory card is in
place, it may have a bad physical connection.
b. Error Type 513: Not enough memory to support system operations, or
memory card is a system-upgrade memory card, which cannot save
translations.
NOTE:
If the memory card is a system-upgrade memory card, then the
switch raises on off-board WARNING.
Table 10-133. Memory Card Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test card-mem
1(a) Memory Card Insertion Test
(#695)
MINOR OFF test card-mem
513(b) Any Memory Card Match and
Read Test (#697)
WARNING OFF test card-mem
1025(c) 104
105
106
107
108
Memory Card Dir. Recovery
Test (#699)
MINOR OFF test card-mem
1281(d) Any Memory Card Translation
Data Integrity Test (#694)
MINOR OFF test card-mem long
1537(e) 104
105
106
107
108
Memory Card
Erase/Write/Read Test
(#693)
MINOR OFF test card-mem long
3329(f) any None MINOR/
MAJOR
OFF
3841(g) Any Save Translation MINOR OFF save translation
3842(h) Any Save Translation MINOR OFF save translation
3843(i) Any Save Translation MINOR OFF save translation
To Next Page
Loading...
