Maintenance Object Repair Procedures
555-233-123
10-352 Issue 4 May 2002
Memory Card Translation Data Integrity Test
(#694)
This nondestructive test verifies the integrity of the translation file stored in the
memory card through comparing checksum values. If the calculated checksum
value and the recorded checksum value are different, the translation file is corrupt.
Table 10-135. TEST #694 Memory Card Translation Data Integrity Test
Error
Code
Te s t
Result Description/Recommendation
2012
2106
2114
ABORT Internal system error
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
2013
2100
none
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
2110
2111
ABORT
ABORT
Memory card not present.
Switch does not recognize the memory card.
1. Insert a formatted memory card into the slot at the
TN2401/TN794 NetPkt or TN777B Netcon circuit pack.
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, escalate the problem.
2112 ABORT Memory card is a system-upgrade memory card.
1. Replace the inserted memory card with a user’s memory
card.
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, escalate the problem.
Any FAIL A checksum error in translation.
1. Verify that the memory card can save translations (save
translation).
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, replace the memory card.
PASS There is no checksum error in the translation file.
Continued on next page
To Next Page
Loading...
