Avaya Definity SI - Page 1137

CARD-MEM (Memory Card)
Issue 4 May 2002
10-351 555-233-123
2115 ABORT Write-protect switch in “protected” position.
1. Remove the memory card from the Processor circuit pack
slot.
2. Push write-protect switch into “not protected” position.
3. Insert the memory card firmly into the Processor circuit pack
slot.
4. Retry the command at 1-minute intervals, up to 5 times.
5. If the problem persists, escalate the problem.
2117 ABORT Translation file not on memory card.
1. Verify that the memory card saves translations (save
translation).
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, escalate the problem.
104 FAIL Corrupt and irrecoverable directories.
105 FAIL Cannot write “0” to the memory card.
106 FAIL Cannot erase memory card.
107 FAIL Cannot write data into memory card after erasing.
1. Replace the memory card.
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, escalate the problem.
110 FAIL Cannot write to old memory card (pre-g3v9). Card format is
post-g3v8.
1. Replace with proper card.
PASS The memory card successfully performs the erase, write, and
read operations.
Table 10-134. TEST #693 Memory Card Erase/Write/Read Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page