CARD-MEM (Memory Card)
Issue 4 May 2002
10-359 555-233-123
2115 ABORT The write-protect switch is set to the “protect” position.
1. Remove the memory card.
2. Move the write-protect switch to the “not-protected”
position.
3. Re-insert the memory card into the slot.
4. Retry the command at 1-minute intervals, up to 5 times.
5. If the problem persists, escalate the problem.
104 FAIL Corrupt and irrecoverable directories.
105 FAIL Cannot write “0” to the memory card.
106 FAIL Cannot erase memory card.
107 FAIL Cannot write data into memory card after erasing.
1. Replace the memory card.
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, escalate the problem.
110 FAIL Cannot write to old memory card (pre-g3v9). Card format is
post-g3v8.
1. Replace with proper card.
PASS Memory card directory files are sane.
Table 10-139. TEST #699 Memory Card Directory Recovery Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page