CLAN-BD (Control LAN Circuit Pack)
Issue 4 May 2002
10-395 555-233-123
Notes:
a. Error Type 1: Circuit pack stopped functioning or is not physically present.
1. Verify that the circuit pack is present.
2. If circuit pack is present, reset the circuit pack (reset board
UUCSS).
3. If the error persists, replace the circuit pack.
b. Error Type 18: The CLAN circuit pack busied out.
c. Error Type 217: applies to 10 circuit packs:
1. Remove the circuit pack(s) against which the error is logged.
d. Error Type 257: Transient communication problem between switch and
circuit pack; does not affect service and can be ignored.
1. Ignore this error, unless the Control Channel Loop Test (#52) fails.
2. If Test #52 fails, replace the circuit pack.
Repetitive failures of the Control Channel Loop Test indicate circuit pack
hardware failure.
e. Error Type 513: Circuit pack detected and reported hardware failure.
1. Reset the circuit pack (reset board UUCSS).
Aux Data:
3842 (t)
3844 (u) Any
3845 (v) Any
3846 (w) Any
3848 (x) Any
3849 (y) Any
3850-
3861 (z)
Any
3862 (aa) Any
4352 External RAM error
4353 Internal RAM error
4355 ROM Checksum error
4356 Angel Message Corruption error
4357 Instruction set error
Table 10-145. CLAN-BD Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
Continued on next page
To Next Page
Loading...
