Maintenance Object Repair Procedures
555-233-123
10-396 Issue 4 May 2002
f. Error Type 769: Logic error. By itself this error may be ignored, but it may
result in other error types being reported.
g. Error Type 1293-1295: Critical hardware or firmware error.
Error Type descriptions are as follows:
1. Attempt to clear the alarm (reset board UUCSS).
2. If alarm persists, replace circuit pack.
h. Error Type 1537: Switch removed hyperactive circuit pack that reported
threshold number of errors.
1. Attempt to clear the alarm (reset board UUCSS).
2. If the error recurs within 15 minutes, replace the circuit pack.
i. Error Type 1794: Packet bus transmit buffers have overflowed.
1. Attempt to clear the alarm (reset board UUCSS).
2. If the error recurs within 15 minutes, replace the circuit pack.
j. Error Type 1798: Unable to write translation RAM.
1. Attempt to clear alarm (reset board UUCSS).
2. If alarm recurs within 15 minutes, replace the circuit pack.
k. Error Type 2049: Packet Interface Test (#598) failed.
1. Attempt to clear the alarm (test board UUCSS l r 3).
2. If alarm does not clear, reset the circuit pack (reset board UUCSS).
3. If circuit pack resets, execute Packet Interface Test (#598) several
times.
4. If Packet Interface Test (#598) continues to fail, replace the circuit
pack.
If the switch detects: Then the switch:
1 error, Resets circuit pack.
3 errors in 15 minutes, Raises MINOR alarm.
1293 Insane onboard processor
1294 Onboard translation RAM error
1295 (Aux 3) RSCL link down
(Aux 0) RSCL keep alive failure
To Next Page
Loading...
