Maintenance Object Repair Procedures
555-233-123
10-440 Issue 4 May 2002
Notes:
a. These are in-line errors that have no specific test associated with them.
b. This is a software audit error that does not indicate any hardware
malfunction. Run the Short Test Sequence and investigate associated
errors (if any).
c. This error type indicates that the circuit pack has been removed or has
been insane for more than 11 minutes. To clear the error, reinsert or
replace the circuit pack.
d. Aux data 57345 -- Single polarity ringing current
Aux data 57376 -- No loop current on incoming call
Aux data 57408 -- No tip ground detected on outgoing call
Aux data 57424 -- No loop current on outgoing call
Aux data 57484 -- No dial tone on outgoing call
2049 NPE Cross Talk Test
(#6)
MAJ/MIN/
WRN
2
ON test port PCSS l r 3
2561 (d) 57345 None
2817 (a) 57360 None
2817 (a) 57393 None
2817 (d) 57484 Dial Tone Test (#0) MAJ/MIN/
WRN
2
OFF test port PCSS l r 1
3073 (d) 57376 None
3329 (d) 57408 None
3329 (d) 57484 Dial Tone Test (#0) MAJ/MIN/
WRN
2
OFF test port PCSS l r 1
3585 (d) 57424 None
3840 (f) 8000 Analog Transmission
(#844-848)
OFF
3841 (f) Analog Transmission
(#844-848)
MINOR OFF test analog testcall UUCSS
pp r 2
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
2 Minor alarms on this MO may be downgraded to warning alarms based on the values used in the set
options command. If the Minor alarm is not downgraded by the set-options values, the Minor alarm
is upgraded to a Major alarm if 75 percent of the trunks in this trunk group are alarmed.
Table 10-163. CO Trunk Error Log Entries — Continued
Error
Type
Aux
Data Associated Test
Alarm
Level
On/
Off
Board Test to Clear Value
Continued on next page
To Next Page
Loading...
