Maintenance Object Repair Procedures
555-233-123
10-488 Issue 4 May 2002
a. Refer to DATA-BD (Netcon or NetPkt Circuit Pack) Maintenance
documentation for a description of these tests.
b. Refer to SW-CTL (Switch Control) Maintenance documentation for a
description of these tests.
c. Refer to CARD-MEM for information on this test.
d. This test runs only as part of the reset switch-control command.
Switch Control Reset Test (#93) (b) (d) D
Time-of-Day Clock Test (#95) (b) X X ND
Control Channel Interface Test (#92) (b) X X ND
Control Channel Transmission Test (#94) (b) X X ND
12-Volt Power Supply Test (#701) (c) X X ND
Memory Card Insertion Test (#695) (c) X X ND
Memory Card Format and Read Test (#696) (c) X X ND
Memory Card Match Test (#697) (c) X X ND
Memory Card Write-Protected Test (#698) (c) X X ND
Memory Card Directory Recovery Test (#699) (c) X X ND
Memory Card Translation Data Integrity Test (#694) (c) X ND
Memory Card Erase/Write/Read Test (#693) (c) X ND
1 D = Destructive, ND = Non-destructive
Table 10-178. System Technician-Demanded Tests: DATA-CHL — Continued
Order of Investigation
Short Test
Sequence
Long Test
Sequence D/ND
1
Continued on next page
To Next Page
Loading...
