System Features
Issue 4 May 2002
5-37555-233-123
Examples of Trunk Group forms are shown in Screen 5-3 and Screen 5-4.
Screen 5-3. Trunk Group Form (Page 1 of 2)
Screen 5-4. Trunk Group Form — E & M Mode (Page 2 of 2)
10. Locate the Tie Trunk port terminal connections at the cross-connect field.
See Table 5-6 on page 5-38.
display trunk-group 10 Page 1 of 5
TRUNK GROUP
Group Number: 10 Group Type: tie CDR Reports? y
Group Name: tr 10 COR: 1 TAC: 110
Direction: two-way Outgoing Display? n Data Restriction? n
MIS Measured? n
Dial Access? y Busy Threshold: 60 Night Service:
Queue Length: 0 Internal Alert? n Incoming Destination:
Comm Type: voice Auth Code? n
TRUNK PARAMETERS
Trunk Type (in/out): wink/wink Incoming Rotary Timeout(sec): 5
Outgoing Dial Type: tone Incoming Dial Type: tone
Disconnect Timing(msec): 500
Digit Treatment: Digits:
Used for DCS? n
ACA Assignment? n
Baud Rate: 1200 Synchronization: async Duplex: full
Incoming Dial Tone? y Maintenance Tests? y
Answer Supervision Timeout: Suppress # Outpulsing? n
Page 2 of 5
TRUNK GROUP
GROUP MEMBER ASSIGNMENTS
Port Name Mode Type Answer Delay
1: B1901 E & M t1 stan
2: B1902 E & M t1 comp
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15:
To Next Page
Loading...
