DUPINT (Duplication Interface Circuit Pack)
Issue 4 May 2002
10-709555-233-123
Duplication Interface Circuit Pack Background
Test Query (#271)
This test queries the Duplication Interface circuit pack for the results of its
background tests. The response indicates the results of the last time the following
background tests were run:
■ ROM Checksum Test: This test verifies the correctness of the Duplication
Interface circuit pack firmware.
■ RAM Test: This tests verifies that the RAM on the Duplication Interface
circuit pack is functioning properly.
Table 10-261. TEST #271 Duplication Interface Circuit Pack
Background Test Query Test
Error
Code
Te s t
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
2000 ABORT Response to the test request was not received within the
allowable time period.
2033 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
2008
2009
2010
FAIL One or both background tests failed on the Duplication
Interface circuit pack. Error Code 2008 means the ROM test
failed. Error Code 2009 means the RAM test failed. Error Code
2010 means both tests failed.
1. Follow the procedures for replacing Common Control
circuit packs and replace the Duplication Interface circuit
pack.
2. Rerun the test.
NO
BOARD
The Duplication Interface circuit pack has failed to reply to
handshaking from either the active Maintenance/Tape
Processor (in the case of Duplication Interface circuit pack A) or
from Duplication Interface circuit pack A (in the case of
Duplication Interface circuit pack B).
1. Refer to NO BOARD description for the Duplication
Interface Circuit Pack Status Query Test (#315).
Continued on next page
To Next Page
Loading...
