DUPINT (Duplication Interface Circuit Pack)
Issue 4 May 2002
10-713555-233-123
Duplication Interface Circuit Pack
Administration Terminal Loop Back Test (#274)
This test loops back data through the UART used to communicate with
administration terminal. The data is generated by the Duplication Interface circuit
pack processor and is looped through the UART. The test is done entirely on the
Duplication Interface circuit pack. The test passes if the data sent matches the
data received. This test does not check the physical serial channel that is printed
on the backplane or carried by the ICC.
Table 10-264. TEST #274 Duplication Interface Circuit Pack Administration Terminal
Loop Back Test
Error
Code
Te s t
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
2000 ABORT Response to the test request was not received within the
allowable time period.
2033 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page
To Next Page
Loading...
