Routine Maintenance Procedures
555-233-123
5-48 Issue 4 May 2002
status isdn-testcall <grp>/<mbr> (query)
test isdn-testcall <grp>/<mbr> [minutes] (start)
NOTE:
Before placing an outgoing ISDN-PRI test call, verify that the FAC on the
System Features Form has been administered as well as the Far End Test
Line No and TestCall Bearer Capability Class (BCC) on the Trunk Group
Administration Form. Furthermore, if the ISDN-PRI trunk is of the "cbc" (call
by call) service type, then the Testcall Service field on Trunk Group
Administration Form must have been administered also.
To initiate an outgoing ISDN-PRI test call in the asynchronous method, use the
following command:
test isdn-testcall <grp>/<mbr> [minutes]
This command enables you to specify a specific the trunk on which to originate
the ISDN-PRI test call.
NOTE:
The optional qualifier can also be used that specifies in minutes the duration
of the test call. If no duration is specified, the default duration is used which
is 8.4 or 9.6 seconds. The qualifier "minutes" accepts the numeric values
one through 120 (that is, two hours = 120 minutes).
Screen 5-6 shows a typical response to test isdn-testcall:
Screen 5-6. Typical Response to Test ISDN-Testcall Command
The meaning of the information displayed in response to the above command is
described in the following list.
■ Port: The port address (PCSSpp) is the port network number, carrier
designation, slot, and circuit of the maintenance object under test.
■ Maintenance Name: The type of maintenance object tested.
■ Test Number: The actual test that was run.
■ Test Results: Indicates whether the test passes, fails, or aborts.
■ Error Code: Additional information about the results of the test. (See the
ISDN Trunk Maintenance documentation for details.)
test isdn-testcall
Port Maintenance Name Test Number Test Result Error Code
1B1501 ISDN-TRK 258 PASS
To Next Page
Loading...
