Avaya Definity SI - Page 1687

HYB-LINE (Hybrid Line)
Issue 4 May 2002
10-901555-233-123
Hybrid Line Local Digital Loop Around Test (#58)
This test checks the control channel between the SPE and the port’s digital
circuitry. The SPE sends transparent data to the on-board microprocessor and
compares the data echoed back. This test is repeated three times.
Table 10-327. TEST #58 Hybrid Line Local Digital Loop Around Test
Error
Code
Te s t
Result Description/Recommendation
ABORT Internal System Error.
1. Retry the command at one-minute intervals a maximum of
5 times.
1000 ABORT System resources required to run this test are not available.
The port may be busy with a valid call. Use display port
PCSSpp to determine the station extension number of the
port. Use status station to determine the service state of the
port. If the service state indicates that the port is in use, then
the port is unavailable for certain tests. (Refer to the “Status
Commands” section in Chapter 10, “Maintenance Commands
and Trouble-Clearing Aids” for a full description of all possible
states.) You must wait until the port is idle before retesting.
Attendants are always in use (off-hook) if the handset is
plugged in and the port is not busied out.
1. If the port status is idle, then retry the command at
one-minute intervals a maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test. The test has
been aborted. Use display port PCSSpp to determine the
station extension number of the port. Use status station to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. (Refer to the “Status Commands” section in
Chapter 10, “Maintenance Commands and Trouble-Clearing
Aids” for a full description of all possible states.) You must wait
until the port is idle before retesting. Attendants are always in
use (off-hook) if the handset is plugged in and the port is not
busied out.
1. Retry the command at one-minute intervals a maximum of
5 times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at one-minute intervals a maximum of
5 times.
Continued on next page