Maintenance Object Repair Procedures
555-233-123
10-1078 Issue 4 May 2002
NT Reset Test (#1381)
This test is destructive.
This test resets the circuit pack. The test is highly destructive and can only be
initiated by a system technician-demanded reset board UUCSS command.
2100 ABORT The necessary system resources to execute the test could not
be allocated.
1. Retry the command at 1-minute intervals a maximum
of 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum
of 3 times.
2801 ABORT No IP address defined. Verify IP Interfaces translations and
retest.
2802 ABORT Different IP address pinged than software had allocated for the
test.
1. Retry the command at 1-minute intervals a maximum
of 3 times.
2805 FAIL The number of pings received did not match the number sent
(normally one ping sent). This means that no ping responses
were received from the gateway defined on the ip-interfaces
form for the Media Processor.
1. Retry the command at 1-minute intervals a maximum
of 3 times.
2807 ABORT The board is administered, but not enabled in the change
ip-interfaces form.
7, 89,
1007
FAIL Ping to the destination failed through this port due to the
destination down.
1. Verify that at least one destination reachable through
this port is up.
2. Once verified, execute test port UUCSSpp command
to verify that the H.323 Signaling Group Ping Test
(#1387) passes.
PASS Ping through this port successful.
Table 10-402. TEST #1379 Ping Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
