Maintenance Object Repair Procedures
555-233-123
10-1152 Issue 4 May 2002
1004 ABORT The port was seized by a valid ISDN-PRI Test Call. Use
list isdn-testcall to determine which call is using the port
(from the M/T Port column). Either wait for the test call to
complete (as indicated in the Start Time and Duration fields
of the above display), or abort the test call with clear
isdn-testcall tg/mem, where tg/mem is determined from
the B-channel field of the above display.
1. Retry the command at one-minute intervals a
maximum of 5 times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at one-minute intervals a
maximum of 5 times.
2100 ABORT System resources required to run this test are not
available.
1. Retry the test at one-minute intervals a maximum of 5
times.
7 FAIL Conference test failed on the primary information channel.
In most cases, the user may not notice a disruption in
service.
1. Run the circuit pack tests to check the Tone Generator
circuit pack and the Tone Detector circuit pack via the
test board PCSS command.
2. Resolve any problems that are detected on the Tone
Generator circuit pack or Tone Detector circuit pack.
3. If the Tone Generator and Tone Detector circuit packs
are functioning properly, and the test still fails, replace
the Maintenance/Test circuit pack.
Table 10-434. TEST #13 Digital Port Loop Around Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
