M/T-DIG (Maintenance/Test Digital Port) [G3iV1-1.286,
G3iV2-386]
Issue 4 May 2002
10-1157555-233-123
Hook State Inquiry (#566)
This test ensures that the Maintenance/Test Digital Port maintenance software
and call processing agree on the on-/off-hook status of the Maintenance/Test
Digital Port.
Table 10-437. TEST #566 Hook State InquiryTest
Error
Code
Tes t
Result Description/Recommendation
1 ABORT Switch hook audit timed out. No response was received
from the circuit pack for information about the switch hook
state.
1. Retry the command at one-minute intervals a
maximum of 5 times.
2. If the test continues to abort, replace the circuit pack
and repeat the test.
2100 ABORT System resources required to run this test are not
available.
1. Retry the command at one-minute intervals a
maximum of 5 times.
Any FAIL Internal System Error. This test should never return a
failure.
1. Retry the command at one-minute intervals a
maximum of 5 times.
2. If the test continues to fail reset the circuit pack via the
busyout board PCSS, reset board PCSS, release
board PCSS command sequence.
3. Retry the command at one-minute intervals a
maximum of 5 times.
PASS Call processing and Maintenance/Test Digital Port
maintenance software agree on the Maintenance/Test
Digital Port hook state.
Continued on next page
To Next Page
Loading...
