OPS-LINE (DS1 OPS Line)
Issue 4 May 2002
10-1177555-233-123
2000 ABORT The test was aborted because response to the test was not
received within the allowable time period.
1. Retry the command at 1-minute intervals for a
maximum of 5 times.
2. If the test aborts with error code 2000 again, run short
test sequence on the associated DS1-BD or
UDS1-BD. If tests 138 through 145 on the associated
DS1-BD or UDS1-BD are also aborting with error code
2000, hyperactivity on the board or facility is indicated.
In this case, the hyperactivity problem should be dealt
with first.
2100 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a
maximum of 5 times.
Table 10-443. TEST #36 Audit and Update Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
