Maintenance Object Repair Procedures
555-233-123
10-1216 Issue 4 May 2002
Table 10-453. TEST #7 Conference Circuit Test
Error
Code
Tes t
Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1000 ABORT System resources required to run this test are not available. The
port may be in use on a valid call. Use the status pri-endpoint
<extension> command to determine when the port is available
for testing.
1004 ABORT The port has been seized by a user for a valid call. Use the status
pri-endpoint <extension> command to determine when the port
is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1020 ABORT The test did not run due either to an already existing error on the
specific port or to a more general circuit pack error.
1. Examine Error Log for existing errors against this port or
against the circuit pack, and attempt to diagnose the already
existing error.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Any FAIL The NPE of the tested port did not conference the tones correctly.
This causes noisy and unreliable connections.
1. Replace the circuit pack. Even though wideband calls do not
use the conferencing feature on the NPE, this failure
indicates problems with the circuit pack hardware.
PASS The port can correctly conference multiple connections.
User-reported troubles on this port should be investigated by
using the other port tests and by examining the terminal adapter
or the external wiring.
Continued on next page
To Next Page
Loading...
