Avaya Definity SI - Page 2083

PKT-INT (Packet Interface)
Issue 4 May 2002
10-1297555-233-123
1026 (j) Any None MAJOR
3
ON reset packet-interface 1CS
4
1281
5
(k) Any None MAJOR
3
ON reset packet-interface 1CS
4
1537 (l) Any Memory Checksum
Test (#884)
MINOR ON test packet-interface 1CS r 2
1793 (m) Any Memory Checksum
Test (#884)
MINOR ON test packet-interface 1CS r 2
2049
5
{n} Any None WARNING ON test packet-interface 1CS r
25
2305
5
(o) Any None test packet-interface 1CS r 2
2561 (p) Any Active-Standby Peer
Link Test (#888)
MINOR OFF test packet-interface 1CS s r
2
2817
5
(q) Any Read and Clear Test
(#887)
MINOR/
MAJOR
3
ON test packet-interface 1CS s
3074 (r)
3073
3072
Any Mtce Looparound
Test (#886)
5
WARNING OFF test packet-interface 1CS s r
2
3329 (s) Any None WARNING OFF reset packet-interface 1CS
4
3585
5
(t) Any None WARNING OFF reset packet-interface 1CS
4
3841
5
(u) Any None MAJOR
3
OFF reset packet-interface 1CS
4
1 C is the carrier location (a or b), S is the instance of the Packet Interface (1 or 2). The carrier location
is required only for duplicated SPEs.
2 Indicates that an alarm was raised but an associated error was not entered into the hardware error
log due to a momentary overload condition caused by a burst of hardware or software error reports.
Run the long test sequence. Refer to the appropriate test descriptions for any failures and follow
the recommended procedures.
3 If a spontaneous interchange has occurred (as indicated by STBY-SPE error type 103 or the
display init causes screen), execute a test long clear of the alarmed circuit pack and follow
recommended procedures.
4 The I/O Processor or Packet Interface instance in the active SPE can only be reset if it has been
taken out of service by background maintenance software. In the standby SPE, the I/O Processor
and Packet Interfaces can be reset independent of service state.
5 The error type or test applies only to Packet Interface 2, i.e., the Packet Interface instance that uses
the packet bus.
Table 10-483. Packet Interface Error Log Entries — Continued
Error
Type
Aux
Data Associated Test
Alarm
Level
On/
Off
Board Test to Clear Value
1
Continued on next page