PPP-PT (Control LAN Packet/Port)
Issue 4 May 2002
10-1361555-233-123
Session Status Test (#1286)
This non-destructive test determines the status of all PPP port sessions. This test
queries the system software on port session status.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. Escalate if the problem persists.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
1003 FAIL Ping to the destination failed due to on-board problem.
1. Retry the command at 1-minute intervals, up to 3 times.
2. If the problem persists, reset the circuit pack (busyout
board UUCSS, reset board UUCSS, and release board
UUCSS).
3. If the problem persists, re-administer the PPP connection
through a different PPP port, if available.
4. If the problem still persists, or if there are no other available
PPP ports, replace the circuit pack.
1007 FAIL Ping to the destination failed due to the destination down.
1. A PPP destination or a component in the path (e.g., DS1
trunk) may be down. Check the status of the destination or
other components in the path.
2. If the destination and all components in the path are
in-service, ping the PPP destinations (ping ip-address
xxx.xxx.xxx.xxx).
3. Escalate if the problem persists.
PASS TCP/IP Ping Test (#1281) is successful.
If the system software indicates that: Then the switch:
All port sessions are up (ALL UP) Raises no alarm, or retires alarm
Some port sessions are up (SOME UP) Raises MINOR alarm
All port sessions are down (ALL DOWN) Raises MINOR alarm
Table 10-502. TEST #1281 TCP/IP Ping Test — Continued
Error
Code
Te s t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
