PR-MAINT (Maintenance Processor [TN2404/TN790
RISC Systems])
Issue 4 May 2002
10-1371555-233-123
Table 10-507. TEST #102 MTP Outpulse Relay Test
Error
Code Test Result Description/Recommendation
100 ABORT The test did not complete within the allowable time period.
1. Retry the command.
1018 ABORT The test has been disabled via administration.
1. To enable the test, issue the change
system-parameters maintenance command, and set
the test remote access port field to “y.” (If you have an
INADS line, set the field to “y.”
2. Rerun the test.
1030 ABORT This test is not run on the Standby SPE.
1131 ABORT INADS port is busy because the system is reporting alarms
to INADS, or because INADS is dialed into the system.
1. If INADS is communicating with the switch the INADS
trunk is working. There is no need to run this test.
2. Or if required. Wait about ten minutes (until the INADS
session is terminated) and then re-enter the command.
1000 ABORT System software resources required for this test are not
available.
1. Retry at 1-minute intervals a maximum of 5 times.
1050 ABORT System could not determine if the testing of the INADS port
is administered.
1. Enter the change system-parameters maintenance
command. Verify that the “Test Remote Access Port?”
field is set to “y.”
2. Retry the command at 1-minute intervals a maximum of
5 times.
2033,
2500
Internal system error
1. Retry at 1-minute intervals a maximum of 5 times.
2000 ABORT MTP did not respond to the test request.
1. Repeat the test at 1-minute intervals a maximum of 5
times.
2. If all MTP tests are aborting, execute the test processor
a/b long command in order to reset MTP and to
examine the results of the MTP Reset Test (#101).
3. Replace the Processor circuit pack.
4. If only the MTP outpulse relay test is aborting, escalate
problem.
Continued on next page
To Next Page
Loading...
