PR-MAINT (Maintenance Processor)
Issue 4 May 2002
10-1399555-233-123
22902
22903
ABORT The system software resources required for this test are not
available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
FAIL The Auxiliary channel failed the Loop Back Test. The AUX port is
probably not sending any auxiliary data to the auxiliary collection
device.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If test continues to fail, replace the Processor circuit pack.
PASS The Auxiliary channel passed the Loop Back Test. The auxiliary
port is functioning correctly.
1. If no auxiliary data is being recorded, check the auxiliary
collection device, and verify that it has been set up and
connected correctly.
Table 10-521. TEST #229 MTP Auxiliary Loop Around Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
