S-SYN-PT (Speech Synthesis Port)
Issue 4 May 2002
10-1481555-233-123
Speech Synthesis PSS Handshake Test (#168)
This test verifies control functionality between the on-board microprocessor and
PSS controller. A failure occurs if either of the following events occur:
■ The on-board microprocessor times out while waiting for the PSS controller
to respond.
■ An invalid command is received by the on-board microprocessor from the
PSS controller.
This type of failure affects all four ports on the Speech Synthesis circuit pack,
resulting in errors or alarms on each port.
Table 10-563. TEST #168 Speech Synthesis PSS Handshake Test
Error
Code
Te s t
Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at one-minute intervals a maximum of 5
times.
1000 ABORT System resources required to run this test are not available. The
port may be busy with a valid call and therefore unavailable for
certain tests. You must wait until the port is idle (yellow LED if off)
before retesting.
1. If the port is idle, retry the command at one-minute intervals
a maximum of 5 times.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at one-minute intervals a maximum of 5
times.
Any FAIL The on-board microprocessor has timed out while waiting for the
PSS controller to respond or an invalid command has been
received by the on-board microprocessor from the PSS
controller. This type of failure may cause features using the
Speech Synthesis Port’s speech services to malfunction.
1. Replace the circuit pack.
PASS The on-board microprocessor/PSS handshake is working
correctly. User-reported troubles should be investigated using
other tests and verifying other ports on this circuit pack are
working correctly.
Continued on next page
To Next Page
Loading...
