Maintenance Object Repair Procedures
555-233-123
10-1482 Issue 4 May 2002
Speech Synthesis Parameter Update Test (#169)
This test updates the DTMF interdigit time-out parameter used by the Speech
Synthesis circuit pack to be consistent with that specified by the switch processing
element (SPE).
Table 10-564. TEST #169 Speech Synthesis Parameter Update Test
Error
Code
Te s t
Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of 5
times.
1000 ABORT System resources required to run this test are not available. The
port may be busy with a valid call and therefore unavailable for
certain tests. You must wait until the port is idle (yellow LED if off)
before retesting.
1. If the port is idle, retry the command at one-minute intervals a
maximum of 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of 5
times.
Any FAIL An internal system error has occurred.
PASS The DTMF interdigit time-out parameter has been updated.
1. User-reported troubles should be investigated using other
tests and by verifying that other ports on this circuit pack are
working correctly.
Continued on next page
To Next Page
Loading...
