Maintenance Object Repair Procedures
555-233-123
10-1546 Issue 4 May 2002
2020 ABORT The test requires that a maintenance activity request be made to the
Standby SPE; however, the request cannot be made because the
Active SPE was restarted within the last five minutes and has not yet
initialized the Standby SPE. Therefore, the Standby SPE is not
available to handle maintenance activity requests.
1. Issue refresh spe-standby to force the Standby SPE to
Standby Mode. This command may have to be issued multiple
times. If refresh spe-standby successfully completes 5 times
without the Standby SPE becoming labeled “standby” on the
status system form, wait 20 minutes. This does not include
cases where the command completes with the terminal
message line errors “Refresh not successful; use ‘display
errors’ to check for STBY-SPE errors” or “Cannot interrupt
Standby SPE while entering maintenance mode; please try
later.” Issue refresh spe-standby once more.
2. Repeat the test.
3. If the Active SPE was restarted with a Cold 1 or a reboot, issue
test spe-standby long to thoroughly test all Standby SPE
components.
2021 ABORT An attempt to refresh Standby SPE memory from Active SPE
memory encountered a problem. In this case, the refresh from
Active SPE Memory to Standby SPE Memory probably succeeded.
However, the following steps should be followed just to verify that
there are no problems.
1. Check for Active SPE Memory errors and alarms. Refer to
MEM-BD (Memory circuit pack) Maintenance and follow the
prescribed maintenance procedures.
2. Issue refresh spe-standby. This command may have to be
issued multiple times. If refresh spe-standby successfully
completes 5 times without the Standby SPE becoming labeled
“standby” on the status system form, wait 20 minutes. This does
not include cases where the command completes with the
terminal message line errors “Refresh not successful; use
‘display errors’ to check for STBY-SPE errors” or “Cannot
interrupt Standby SPE while entering maintenance mode;
please try later.” Issue refresh spe-standby once more.
Table 10-578. Test Result Error Codes Associated with the Standby SPE — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
