Maintenance Object Repair Procedures
555-233-123
10-1552 Issue 4 May 2002
2025
(cont’d.)
ABORT 6. Issue display errors and check to see if an Error Type 80 is
logged against STBY-SPE. If so, the problem is the carrier A
Duplication Interface circuit pack. Replace the carrier A
Duplication Interface circuit pack as described in Chapter 6,
‘‘Reliability Systems: A Maintenance Aid’’ and proceed with
Steps 10, 11, and 12.
7. Issue display errors and check to see if an Error Type 82 is
logged against STBY-SPE. If so, the problem is the carrier B
Duplication Interface circuit pack. Replace the carrier B
Duplication Interface circuit pack as described in Chapter 6,
‘‘Reliability Systems: A Maintenance Aid’’ and proceed with
Steps 10, 11, and 12.
8. Issue display errors and check to see if Error Type 85 is
logged against STBY-SPE. If so, the problem may be the
Standby SPE Memory circuit pack. Replace the Memory circuit
pack as described in Chapter 6, ‘‘Reliability Systems: A
Maintenance Aid’’ and proceed with Steps 10, 11, and 12.
9. Issue display errors and check to see if Error Type 58 is
logged against STBY-SPE. If Error Type 58 is logged OR if no
error type is logged, the problem is either the Standby SPE
Processor circuit pack, the Standby SPE Memory circuit pack,
or the carrier A Duplication Interface circuit pack.
■ If the red LED on the Standby SPE Processor circuit pack is
on and the Standby SPE Processor circuit pack has not
been replaced yet, replace the Standby SPE Processor
circuit pack as described in Chapter 6, ‘‘Reliability Systems:
A Maintenance Aid’’ and proceed with Steps 11, 12, and 13.
If the red LED on the Standby SPE Processor circuit pack is
on, and if the Standby SPE Processor circuit pack has been
replaced, replace the Standby SPE Memory circuit pack as
described in Chapter 6, ‘‘Reliability Systems: A Maintenance
Aid’’ and proceed with Steps 11, 12, and 13.
Table 10-578. Test Result Error Codes Associated with the Standby SPE — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
