STBY-SPE (Standby SPE)
Issue 4 May 2002
10-1553555-233-123
2025
(cont’d.)
ABORT ■ If the red LED on the Standby SPE Memory circuit pack is
on, replace the Standby SPE Memory circuit pack as
described in Chapter 6, ‘‘Reliability Systems: A Maintenance
Aid’’ and proceed with Steps 10, 11, and 12.
■ If the red LED on the carrier A Duplication Interface circuit
pack is on, replace the carrier A Duplication Interface circuit
pack as described in Chapter 6, ‘‘Reliability Systems: A
Maintenance Aid’’ and proceed with Steps 11, 12, and 13.
■ If none of the three red LEDs is on AND if this is the first
attempt to clear the problem, replace the Standby SPE
Processor circuit pack as described in Chapter 6, ‘‘Reliability
Systems: A Maintenance Aid’’ and proceed with Steps 10,
11, and 12.
■ If none of the three red LEDs is on AND if this is the second
attempt to clear the problem (that is, the Standby SPE
Processor circuit pack has already been replaced), replace
the Standby SPE Memory circuit pack as described in
Chapter 6, ‘‘Reliability Systems: A Maintenance Aid’’ and
proceed with Steps 10, 11, and 12.
■ If none of the three red LEDs is on AND if this is the third
attempt to clear the problem (that is, the Standby SPE
Processor and Standby SPE Memory circuit packs have
already been replaced), replace the carrier A Duplication
Interface circuit pack as described in Chapter 6, ‘‘Reliability
Systems: A Maintenance Aid’’ and proceed with Steps 10,
11, and 12.
Table 10-578. Test Result Error Codes Associated with the Standby SPE — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
