SW-CTL (Switch Control)
Issue 4 May 2002
10-1579 555-233-123
Control Channel Transmission Test (#94)
Control channel messages are sent from the SPE to selected port circuit packs
and the response from the port circuit packs is checked. This tests the ability of
the Switch Control to send and receive messages on the control channel of the
TDM Bus.
This test cannot run on the Standby SPE Switch Control. Therefore, it is possible
to have defective hardware on the Standby NetPkt or Netcon circuit pack that is
not detectable.
Table 10-584. TEST #94 Control Channel Transmission Test
Error
Code
Te s t
Result Description/Recommendation
0 ABORT The port circuit packs necessary for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, then replace the NetPkt or
Netcon circuit pack.
1030 ABORT The Switch Control on the Standby SPE is being tested
1. For recommended maintenance procedure, refer to
ABORT Error Code 1030 in STBY-SPE Maintenance
documentation.
2012 ABORT Internal system error
2013
2100
none
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page
To Next Page
Loading...
