Maintenance Object Repair Procedures
555-233-123
10-1622 Issue 4 May 2002
Tape Reset Test (#67)
This test resets the tape portion of the Processor on the Maintenance/Tape
Processor (PR-MAINT), and it resets the shared RAM on the Processor circuit
pack (TN770). The test can pass when no drive is present because it never
accesses the tape drive.
Any
Others
ABORT or
FAIL
Refer to Table B in ‘‘Tape Unit Aux Data/Error Codes
Tables’’ and follow the recommended repair strategy for
specific Aux Data.
PASS This is a comprehensive test of the Tape Unit. The test
verifies that the tape drive is in good working order.
Table 10-598. TEST #67 Tape Reset Test
Error
Code
Te s t
Result Description/Recommendation
1029 to
2051
ABORT Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
9000’s FAIL Refer to Table A in ‘‘Tape Unit Aux Data/Error Codes Tables’’
and follow the recommended repair strategy for specific Aux
Data.
Any
Others
FAIL Refer to Table B in ‘‘Tape Unit Aux Data/Error Codes Tables’’
and follow the recommended repair strategy for specific Aux
Data.
PASS Communication with the tape processor is possible at a very
basic level.
Continued on next page
Table 10-597. TEST #66 Tape Diagnostic Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
