Maintenance Object Repair Procedures
555-233-123
10-1660 Issue 4 May 2002
LAN Receive Parity Error Counter Test (#595)
This test is nondestructive. The test reads and clears the circuit pack’s LAN
Receive Parity Error Counter. This counter increments when it detects a parity
error from the Packet Bus. These errors may indicate problems with a circuit pack,
Packet Bus, or with another circuit pack on the bus. Use this test to verify the
repair.
Table 10-609. TEST #595 LAN Receive Parity Error Counter Test
Error
Code
Te s t
Result Description/Recommendation
2000 ABORT Response to the test was not received from the circuit pack
within the allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset
the circuit pack via the busyout board PCSS and reset
board PCSS commands.
2. If the test aborts again, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run
this test.
Continued on next page
To Next Page
Loading...
